Some matters needing attention in the working environment of WEDM

1. Choose a place without dust and avoid leaving many channels next to the online cutting;
The characteristics of the wire cutting and discharging machine itself, and the presence of dust in the air, will cause the screw of the machine to be severely worn, thus affecting the service life;
The wire-cutting discharge machine belongs to the computer control. The disk used by the computer has very strict requirements on the dust in the air. When the dust in the disk enters, the disk will be damaged and the hard disk will be damaged.
The wire-cutting discharge machine itself generates a lot of heat, so the electrical cabinet needs frequent air exchange. If there is too much dust in the air, it will accumulate on the various electrical components during the air exchange process, resulting in poor heat dissipation of the electrical components, resulting in the circuit board Burned out. Therefore, the machine dust screen should be cleaned frequently.
2. Choose a place that can withstand the weight of the machine;
3. Choose places where vibration and impact are not introduced. Wire-cutting discharge machines are high-precision machining equipment. If there are vibrations and impacts at the places where they are placed, they will cause serious damage to the machine table, which will seriously affect the machining accuracy and shorten the machining accuracy. Its service life can even cause the machine to be scrapped.
4. Satisfy the space required by the wire cutting machine;
5. Select a location where the temperature changes little, avoid direct sunlight through the window and top window glass and near the heat flow
High-precision parts processing products need to be carried out at a constant temperature, generally room temperature 20C;
Since the wire cutting discharge machine itself generates a considerable amount of heat during operation, if the temperature change is too large, the service life of the machine may be seriously affected.
6. Select a shielded house: Since the wire-cut EDM process is an arc discharge process, strong electromagnetic waves will be generated during the arc discharge process, thereby causing damage to human health and affecting the surrounding environment.
7. Choose a well-ventilated, spacious factory so that the operator and the machine can work in the best environment.